A.J. Antunes & Co WD-20D 9400171 - Manual (Page 3)

3 P/N 1011152 Rev. A 03/12
Important Safety
Information
Use the following guidelines for safe opera-
tion of the unit:
• Read all instructions before using
equipment.
• For your safety, the equipment is fur-
nished with a properly grounded cord
connector. Do not attempt to defeat
the grounded connector.
• Install or locate the equipment only
for its intended use as described in
this manual. Do not use corrosive
chemicals in this equipment.
• Do not operate this equipment if it
has a damaged cord or plug, if it is
not working properly, or if it has been
damaged or dropped.
• This equipment should be serviced by
qualified personnel only. Contact the
nearest Roundup Authorized Service
Agency for adjustment or repair.
• Do not block or cover any openings on
the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge
of table or counter.
• Turn the unit off, unplug the power
cord, and allow unit to cool down
before performing any service or
maintenance on the unit.
• The procedures in this manual may
include the use of chemical products.
These chemical products will be
highlighted with bold face letters fol-
lowed by the abbreviated HCS (Hazard
Communication Standard). See Hazard
Communication Standard manual for
the appropriated Material Safety Data
Sheets (MSDS).
• The equipment should be grounded
according to local electrical codes to
prevent the possibility of electrical
shock. It requires a grounded recep-
tacle with separate electrical lines,
protected by fuses or circuit breaker of
the proper rating.
• Do not clean this appliance with a
water jet.
Warnings
Be advised of the following warnings when
operating and performing maintenance on
this unit.
• If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent, or a similarly qualified
person in order to avoid a hazard.
• Do not modify the power supply cord
plug. If it does not fit the outlet, have
a proper outlet installed by a qualified
electrician.
• Do not use an extension cord with this
appliance.
• Check with a qualified electrician if
you are unsure if the unit is properly
grounded.
• If a chemical cleaner is used, be sure
it is safe to use on cast aluminum.
Observe all precautions and warnings
on product label.
• Inspection, test, and repair of electrical
equipment should only be performed
by qualified service personnel.
• Chlorides or phosphates in clean-
ing agents (e.g. bleach, sanitizers,
degreasers or detergents) could cause
permanent damage to stainless steel
equipment. The damage is usually in
the form of discoloration, dulling of
metal surface finish, pits, voids, holes,
or cracks. This damage is permanent
and not covered by warranty. The
following tips are recommended for
maintenance of your stainless steel
equipment:
• Always use soft, damp cloth for clean-
ing, rinse with clear water and wipe
dry. When required, always rub in
direction of metal polish lines.
• Stains and spots should be removed
using a vinegar solution.
• Finger marks and smears should be
removed using soap and water.
• Do not use an extension cord with this
appliance.
• Electrical ground is required on this
appliance.