A.J. Antunes & Co WD-35A 9400156 - Manual (Page 8)

WARMER DRAWER
8 P/N 1010889 Rev. A 04/05
WARNING
Turn the unit off, disconnect the power source and
allow the unit to cool down before performing any ser-
vice or maintenance on the unit.
MAINTENANCE
Cleaning
DAILY
1. Turn the unit off, unplug the power cord, and
allow the unit to cool down before proceeding.
2. Remove all parts from inside the Warmer Drawer.
Wash all parts in soap and water, rinse in clear
water, and wipe dry.
3. Wipe the exterior of unit with a damp cloth or
stainless steel cleaner, then wipe dry with a
clean, dry cloth.
4. Re-install all parts into Warmer Drawer.
NOTE: Failure to porperly clean and dry the parts
prior to re-assembly may result in the accumula-
tion of water/moisture overnight. This may lead to
permanent damage of the equipment finish and its
accessories. This damage is permanent and not
covered by warranty.
CAUTION
To prevent damage to the unit, do not use abrasive
cleaners on the unit.
WARNING
Use caution when using caustic cleaning solutions.
Read all manufacturer label instructions to avoid per-
sonal injury.
Figure 4. Removing Drawer
Press down simultane-
ously on both the left and
right interlocking tabs to
release the Drawer
WEEKLY
1. Turn the unit off, unplug the power cord, and allow
the unit to cool down before proceeding.
2. Remove all parts from the Warmer Drawer. Wash
all parts in soap and water, rinse in clear water,
and wipe dry.
3. Pull the Drawer out (Figure 4). Push down simul-
taneously on both the interlocking tabs (above
each drawer side rail - Figure 4) and pull the
Drawer away from unit.
4. Wipe the interior of the Warmer Drawer with a
clean, damp cloth. Then, whipe dry with a clean,
dry cloth.
3. Wipe the exterior of unit with a damp cloth or
stainless steel cleaner, then wipe dry with a clean,
dry cloth.
4. Re-install all parts into unit.
Replacing Components
NOTE: It is recommended that all service proce-
dures be performed by a qualified authorized ser-
vice technician.
Drawer
Side
Rail
Drawer