Specifications, Appendix a: specifications, Aappendix – ADC Network Unit User Manual
Page 29: Pecifications
A-1
A
Appendix
S
PECIFICATIONS
Specifications for the ENIU are listed in
Table A-1. Ethernet NIU Specifications
PARAMETER
SPECIFICATION
Remarks
Power
Voltage
–48VDC, or 110 to 240VAC (50–60 Hz)
Operating Voltage
+5 VDC
Backplane connector
Input Current
0.25 A maximum
Normal operation
Fuse Size
1.0 Amps
–48 VDC
Environmental
Operating Conditions
+23
°
F to +122
°
F (–5
°
C to +50
°
C) 5% to 90% RH
Storage Conditions
-40
°
F to +185
°
F (-40
°
C to +85
°
C) 10% to 95% RH
No Condensation
Mechanical
Dimensions D x W x H
1.55 in.
×
4.25 in.
×
9.09 in.
(3.94 cm
×
10.8 cm
×
23.1 cm)
Weight
1.8 lb. (0.81 kg.)
Electrical
Network Interface
RJ-45, SFP
Network Data Rates
Configurable to 10Mbps, 100Mbps or 1000Mbps
Customer Interface
RJ-45, SFP [Small Form-factor Pluggable (SFP)
Transceiver Multi-Source Agreement (MSA)]
Customer Data Rates
Configurable to 10Mbps, 100Mbps or 1000Mbps
Copper Media
Requirements
10Mbps UTP Category 3, 4, 5 or better
Two twisted pair
100Mbps UTP Category 5 or better
Two twisted pair
1000Mbps UTP Category 5e or better
Four twisted pair
Distance
328 feet (100 meters)
Copper
Optical Media Requirements 850 to 1550 nm
Single Mode or Multi-Mode
fiber
Distance
The maximum distance that any optical link can
support is dependent upon attenuation and dispersion
at a particular wavelength, maximum bit rate, receiver
sensitivity, splice and connector loss, etc. Refer to SFP
specifications for operating parameters.
Optical