ADC Network Unit - Manual (Page 27)

August 7, 2006 Chapter 3: Provisioning
AIWN-UM-7001-01 3-9
Exit
Purpose:
Log off of a command line session.
Command: [all privileges]
EXIT
Inventory
Purpose:
Shows hardware and firmware versions as well as ADC catalog and part numbers.
Command: [all privileges]
GET INVENTORY
LED test
Purpose:
Perform an LED test for the front panel LEDs.
Command: [RW, SECURE privilege]
SET LED TEST
Reset
Purpose:
Restart the firmware in the ENIU.
Command: [RW, SECURE privilege]
RESET
Software Maintenance
Purpose:
Load new software.
Command:[SECURE privilege]
START DOWNLOAD
Starts the XMODEM protocol on the craft port to allow downloading of new firmware.
SAVE DOWNLOAD
Saves a successful firmware download so that it will become the operational software.
Status Commands: [all privileges]
GET DOWNLOAD STATUS