ADC Network Unit - Manual (Page 17)

August 7, 2006 Chapter 2: Installation
AIWN-UM-7001-01 2-5
Table 2-1. 10/100 Mbps Ethernet RJ-45 Connector
Table 2-2. 1000BaseT Ethernet RJ-45 Connector
Optical Cables
The maximum distance that any optical link can support is dependent upon attenuation and dispersion at a
particular wavelength, maximum bit rate, receiver sensitivity, splice and connector loss, and the data rate used.
Refer to SFP specifications for operating parameters.
Pin # Signal Name Function Pin # Signal Name Function
1 TX+ Transmit Data 2 TX– Transmit Data
3 RX+ Receive Data 4 --- Not used
5 --- Not used 6 RX– Receive Data
7 --- Not used 8 --- Not used
Pin # Signal Name Function Pin # Signal Name Function
1 BD1+ Bidirectional 2 BD1– Bidirectional
3 BD2+ Bidirectional 4 BD3+ Bidirectional
5 BD3– Bidirectional 6 BD2– Bidirectional
7 BD4+ Bidirectional 8 BD4– Bidirectional
The maximum cable length is the cable length that the signal can travel without suffering from critical
attenuation (degradation).