Nikon EDG User Manual

Page 16

Adjusting an eyecup's position

Turn and slide eyecups

Fully retracted position

Fully extended position

(As viewed from the eyepiece side)

Turn eyecup counterclockwise to
extend.

Turn eyecup clockwise to retract.
There are four click positions.

● Non-eyeglass wearers:
Extend the eyecup for use (third

click position).

Note: Do not rotate eyecups

beyond the third click position as
they may detach. There are two
click positions before reaching
the fully extended position.

Position where vision is most

accurate and comfortable for
your use.

● Eyeglass wearers:
Use with the eyecups in their fully

retracted position.

If a wide, accurate view can be

obtained, you can also use the
middle click position.

Horn-shaped rubber eyecups

when mounted

Caps when mounted

● Cannot be used with

eyeglasses. Please take off
your eyeglasses before use.

● The horn-shaped rubber

eyecups are attached by
covering the rubber eyepieces.

● Adjust the horns of the

eyecups to match your
temples by observing the
following points:

・ Match the distance between

right and left eyepiece tubes
with your interpupillary
distance by moving the
tubes further apart or closer
together.

・ Set the eyecups to the fully

retracted position.

・ When mounting the

eyecups, be careful not to
change their length.

Horn-shaped rubber eyecups

Eyecap

①

① Neckstrap eyelet
Attach the neckstrap through the eyelet for

security.

At the maximum interpupillary distance, eyecaps
are removed easily.
When the interpupillary distance is narrowed,
eyecaps are difficult to remove because of friction.