Spektrum SPMAR6410T User Manual

Page 9

After Binding

Once the system is bound, the transmitter should always be turned on first and

then the receiver to prevent the receiver from re-entering bind mode. If your recei-

ver inadvertently enters bind mode, simply unplug the battery from the receiver and

reinstall with the transmitter remaining on.

Advanced Programming Features

The following programming features are only recommended for advanced radio

users. To safely accomplish advanced programming feature changes, please enlist

the use of a helper; one person to hold the aircraft to prevent unintended flyaways,

and a second person to make the changes on the transmitter. The procedures

below apply to all compatible transmitters. Prior to making any advanced program-

ming feature changes it is necessary to:

Computer Radios like the DX6i, DX7 amd DX8

1. Choose an empty model location
2. Select model type ACRO
3. Perform a model reset
4. Set all channels to normal reversing
5. Ensure a successful bind has been established
NOTICE: All changes made in advanced programming must start with the receiver

powered down to prevent the motor from running unexpectedly.

Reversing Servos

Servo reversing may be achieved using the servo reversing function of your

transmitter, or as certain advanced applications require it, you may reverse the

actual servos by following the instructions and diagrams below.

Reversing The Servos on the Receiver Board

This feature reverses the servos at the board level, making it useful for implemen-

ting features (such as elevons) while using transmitters with limited programming

options.

NOTICE: All changes made in advanced programming must start with the receiver

powered down to prevent the motor from running unexpectedly.

To safely accomplish advanced programming feature changes, please enlist the

use of a helper. One to hold the aircraft to prevent unintended flyaways, and one to

make the changes on the transmitter.

Sticks must be held in this position while the transmitter is on and the

receiver is off.

1. Ensure a successful bind was completed
2. Turn transmitter on
3. Move THRO stick to full throttle position
4. Move control sticks to the corresponding position for the servo to be reversed

(see illustration)