Spektrum SPMAR6410T - Manual (Page 12)

EN
12
7. The LED on the receiver will go solid and within 5 seconds the LED will flash 3
times quickly, indicating the option is now changed
8. Disconnect battery from receiver
9. Turn transmitter off
Mode 1 Mode 2
Troubleshooting Guide
Problem Possible Cause Solution
Aircraft will
not “throttle
up”but all other
controls seem
to function.
User did not lower throttle
trim and throttle stick prior
to initializing theaircraft.
Lower throttle stick and
throttle trim to their lowest
settings.
Throttle channel is reversed.
Note: Futaba transmitters
(equipped with Spektrum
modules) may require
you to reverse the throttle
channel.
Reverse throttle channel
on specific transmitter if
applicable.
LED on aircraft
remains
flashing and
cannot be
controlled by
transmitter.
User did not wait at least
5 seconds after powering
the transmitter prior to
connecting the flight battery
to the aircraft.
Unplug, then reconnect
flight battery.
Rebind aircraft to your
desired compatible
transmitter.
User bound the aircraft to a
different transmitter.
Rebind aircraft to your
desired compatible
transmitter.
Transmitter was too close
to aircraft during the
initialization process
Move transmitter
(powered on) a few feet
from the aircraft prior to
reconnecting the flight
battery.
CH5/X-port
1. Full THRO
2. Right RUDD
THRO/RUDD ELEV/AILE
ELEV/RUDD THRO/AILE