Spektrum SPMAR6335 AS3X_Programmer - Manual (Page 7)

7
EN
™
AS3X Settings
The Initial Setup menu enables you to view individual screens without using
the Wizard. You will also use the Initial Setup menu to perform a Model Reset,
share model files via e-mail or access the Wizard. Some screens in the Initial
Setup menu also have programming capabilities that are not available in the
Wizard.
Initial Setup
Select the transmitter channel you wish to use for the Flight Mode switch.
Tip: If you wish to use the Gear channel for flight modes, but also wish
to use a 3-position switch, you will need to assign the Gear channel to a
3-position switch in the transmitter.
The Port Assignment screen enables you to change the receiver port
assignment for each surface.
CAUTION: Changing the port assignments may cause issues with
other control surfaces or mixes that you have programmed in your
transmitter. Always perform a control test and set failsafe values before
flying your aircraft. Failure to do so may result in the aircraft crashing.
• Gray port assignemnts are not in use.
• Orange port assignments are currently in use.
• Red port assignments are currently being used as part of a
mix.
IMPORTANT: If you select Aircraft Type in the Initial Setup menu, the
following pop-up alert appears:
“Reselecting your aircraft type will reset all your surface settings. Are
you sure you want to continue.”
If you select “Continue”, you must re-program all of your travel values, dual rates,
etc.
Flight Mode Switch
Port Assignment
Wing Type
Surface Setup is the last step in the Wizard. Press the in the upper right
corner to save settings and exit the Wizard. The application will display the
AS3X Settings menu after exiting the Wizard.
Exit the Wizard