Spektrum SPMMSJR720 - Manual (Page 9)

Spektrum Air Module 16 Spektrum Air Module 17
It’s necessary to program the receiver to the specific module so that the receiver
will only recognize that module, ignoring signals from any other sources. If the
receiver is not bound to the module, the system will not operate. During binding
the servo’s failsafe positions are stored.
The following sequence shows the binding procedure for the AR7000; however, all
Spektrum aircraft receivers are bound in the same way.
How to Bind
The AR7000 receiver must be bound to the module before it will operate.
Binding is the process of teaching the receiver the specific code of the transmitter
so it will connect to that specific module. Once bound, the receiver will only
connect to that module.
2. Turn on the receiver switch. Note that the LEDs on both receivers should be
flashing, indicating that the receiver is ready to bind.
3. Establish the desired failsafe stick positions: normally low throttle and flight
controls neutral.
Binding
1. With the system hooked up as shown, insert the bind plug in the
charge plug receptacle.
Binding