Spektrum SPM20220 DX2.0 - Manual (Page 7)

12 13
The DX2.0 features DSM technology and is compatible with Spektrum DSM and DSM2
surface receivers and the marine receiver.
CompATiBlE SpEkTRum RECEivERS
The DX2.0 is compatible with the following receivers.
Note: The DX2.0 operates in 16.5ms frame rate.
DSM: SR300 - 3-channel Sport - SPMSR300
SR3000 - 3-channel Standard - SPM1200
SR3001 - 3-channel Pro - SPM1205
SR3300T - 3-channel with built-in telemetry - SPMSR3300T
SR3500 - 3-channel Micro Race - SPM1210
Note: The SR3000HRS (SPM1202) receiver is designed to be used with
Spektrum’s Futaba HRS compatible module system only and is not compatible
with the DX2.0.
DSM2: SR3100 - 3-channel Pro - SPMSR3100
SR3520 - 3-channel Micro Pro - SPMSR3520
Marine: MR3000 - 3-channel Marine - SPMMR3000
Please note that DSM2 and marine compatible transmitters can be identified by the following
logo located on the back of the transmitter:
Note: When using a separate NiMH receiver as a power source, the operating voltage
range is 4.8–6.0V (4–5 cells) under load.
Attention: Make sure the male and female connectors have the correct polarity (+/–)
before connecting. Be sure to orient the servo plug correctly for proper insertion.
Most electronic speed controllers are set up for BEC (Battery Elimination Circuitry) operation
and plug directly into your receiver. See Figure A for a typical setup and check your speed
controller’s manual for correct installation.
7.2V Battery To Motor
Electronic
Speed Controller
Receiver
Servo
Figure A – Connections to BEC and receiver with electronic speed controller. NiMH battery
speed controller and servos are not included in the radio set.
Receiver
Compatibility
Receiver
Connections
and
Installation
Key Use
SCROLL Used to move up through the available functions
CHANNEL Used to select the desired channel
INCREASE Used to increase the value of the selected function
DECREASE Used to decrease the value of the selected function
To enter the System Mode press the SCROLL
and CHANNEL keys simultaneously and hold
while turning on the transmitter.
To enter the Function Mode, press the SCROLL
key while the transmitter is on.
Press the INCREASE and DECREASE
keys simultaneously to clear the screen or
return to factory preset.
Key Input and
Display
Located on the left-hand side of the transmitter is the charging jack, which accepts only JR
or Spektrum style wall chargers. Please do not attempt to use any other brand of wall charger
as it may be reverse polarity and can cause damage to your system. Only use the JR or
Spektrum type wall charger when the DX2.0 is equipped with NiMH batteries.
Warning: Charge only rechargeable batteries. Non-rechargeable batteries may burst
causing injury to persons and/or damage to property. Risk of fire and electric
shock. Dry location use only.
Charger Pigtail For Transmitter
Spektrum Transmitter Charge Jack Polarity
Charging Jack
Black To positive
Black With White Stripe To Negative
SCROLL
ENtER
ChaNNEL INCREaSE
CLEaR
DECREaSE
n