Blodgett BC-20G - Manual (Page 28)

24
Maintenance
deliming
4. When the delime lamp goes out, the oven can be
used normally.
To Cancel the deliming Process
1. To cancel the deliming process, push and hold the
Steam on Demand knob. The display reads “DELIME
ABORT NO”.
2. Rotate the timer knob until the display reads “DELIME
ABORT YES”. Push the timer knob.
If the delime process was not required or chemical
has not been pumped into the boiler yet, the delime
is immediately cancelled.
If chemical is in the boiler, the delime process will ad-
vance to step 9 of the process in order to flush the
chemical from the boiler.
BC WITH MEnUSELECT™ COnTROL
When it is time to delime your BCX, the display reads
“DELIME REQUIRED START DELIME YES”. To postpone
the delime, turn the knob until the display reads “DELIME
REQUIRED START DELIME NO”. Push the knob.
DELIME REQUIRED
YES
START
DELIME
Figure 14
The message will return until the unit is delimed. This is a
warning only, the oven can be used all day before delim-
ing. The delime sequence can be run at anytime.
NOTE: Once the deliming process has been started, the
oven cannot be used until deliming is complete,
approximately 45 minutes.
deliming the Boiler with the MenuSelect™ Control
1. If the oven is hot, place in the Cool Down mode with
the door open until the cavity is below 140ºF (60ºC).
2. After the cool down the unit will automatically turn it-
self off. Close the door. Press the maintenance key.
If a delime is required when the power key is pressed,
the display reads “DELIME REQUIRED START DE-
LIMING YES”. In this case, skip to step 5.
Figure 15
3. Turn the dial to highlight “DELIME”. Press the center
of the dial to select.
1. OVEN SETUP
2. SERVICE
3. DELIME
4. FLUSH
Figure 16