Allied Telesis AT-MC1001SC/GS4 - Manual (Page 24)

14
6. Plug the AC/DC power adapter into an appropriate AC power outlet and
insert the power plug into the DC receptacle located on the back of the
unit. (This step does not apply if you installed the unit in an AT-MCR12
chassis.)
Figure 7 12 V DC Connector on the Back of the Media Converter
7. Verify that the PWR LED is green.
8. Remove the dust covers from the fiber optic connectors.
9. Connect the fiber optic cables to the fiber optic ports on the media
converter.
10. Connect the other end of the fiber cables to the desired end stations.
Note
End stations used with the media converter must operate with the same
duplex mode (either both full-duplex or both half-duplex).
Refer to “Testing and Troubleshooting the Media Converter” on page 15 for
further instructions.
12 V D C