Allied Telesis AT-VIEW PLUS 2.3 DEVICE MANAGER - Manual (Page 9)

Allied Telesyn AT-VIEW PLUS
DEVICE MANAGER
PN 613-50504-00 Rev C Page 9 of 121
2.1 Starting From the Command Line
The command line interface is the most basic way to start AT-View Plus Device Manager.
Topics:
• Command Syntax
• Target Host
• Get Community
• Set Community
• Trap Community
• Titlebar String
• Parameter File
2.1.1 Command Syntax
To start AT-View Plus Device Manager from the command line, use the following syntax.
devicemanager [options]
You can specify the following options:
TargetHost
Target host's IP address or DNS host name.
GetCommunity
SNMP Get community string. This is used when retrieving MIB values.
SetCommunity
SNMP Set community string. This is used when modifying MIB values.
TrapCommunity
SNMP Trap community string. This is used when receiving Traps from agents.
DisplayName
Titlebar string.
2.1.2 Target Host
The target host can be specified by entering the IP address of the device or its host name.