Allied Telesis AR700 Series Router - Manual (Page 19)

Installation and Safety Guide
19
To connect via a LAN, use an Ethernet cable to connect the router’s switch
port(s) to the device(s) on the LAN. Select the LAN PC from which you
wish to configure the router. The PC should be in the same subnet as the
part of the LAN that contains the router (for example, the PC could be
connected to a hub or Layer 2 switch that is directly connected to one of
the router’s switch ports).
2. Assign the PC an IP address in the same subnet as the router.
The router’s default IP address is 192.168.1.1.
3. Browse to the GUI.
If you access the Internet through a proxy server, set your browser to
bypass the proxy for 192.168.1.1. Point your web browser at 192.168.1.1.
4. Log in and set the password.
At the log in prompt, enter the log in name and password. Passwords are
case sensitive.
User Name: manager
Password: friend
The system status page appears and you can now use the GUI to configure
the router.
Important To ensure configuration settings are saved correctly, use the
GUI menus and buttons to navigate, not your browser’s buttons.
Caution As a security precaution, change the password as soon as
possible. Remember the new password, as there is no way to retrieve it if it
is lost.
3 4 2 1
10BASE-T/100BASE-TX SWITCH PORTS
POWER
ON
OFF
AR750S Router
PC Hub or Layer 2 Switch
Switch Ports
0
1
1
2
3 5 ASYN0 PIC BAYS
PIC0
PIC1
4
SYS
PWR
ETHERNET STATUS
0 1
L/A
D/C
L/A
D/C 1 2 3 4 5 0
1
SWITCH PORTS PIC
ETHERNET CONSOLE SWITCH PORTS
AR750S Modular VPN Router