Troubleshooting, Where to find more information – Allied Telesis AT-PWR9000 User Manual
Page 8
8
AT-RPS9000 & AT-PWR9000
C613-04040-01 REV C
Troubleshooting
If the RPS does not function as expected, follow these steps:
1.
Check all cable connections are correct and secure.
2.
Check that AT-PWR9000 units are installed in the correct bays (bays that
have AC input and DC output cables connected).
3.
Check the standby switches for the appropriate bays have been pressed,
and are in the ON position.
4.
Check the RPS is receiving the correct AC voltage.
5.
If the LEDs indicate a switch fault, replace the switch or have it serviced by
authorised service personnel.
If the LEDs still indicate a fault, but no fault exists on the switch or power
supply circuits, or if the LEDs indicate an RPS fault, contact your authorised
Allied Telesis distributor or reseller.
Where to Find More Information
Sources of further information:
■
The AT-RPS9000 Statutory and Safety Information booklet, which includes
important safety information and statutory declarations for the
AT-RPS9000 chassis and AT-PWR9000 power unit.
■
The AT-9800 Series Statutory and Safety Information booklet, which includes
important safety information and statutory declarations for AT-9800 Series
switches.
■
The AT-9800 Series Switch Quick Install Guide, which outlines the procedure
for installing AT-9800 Series switches.
■
The AT-9800 Series Switch Hardware Reference, which includes detailed
hardware specifications and pinout information for the RPS.
■
The AT-9800 Series Switch AlliedWare™ Operating System Software Reference,
which provides detailed information on configuring the switch and its
software.
These documents can be downloaded from