Allied Telesis AR400 Series Router - Manual (Page 30)

30 AR400 Series Router
613-000313 Rev B
1. Connect the PC to a router switch port.
The PC can be connected directly, or through your LAN.
To connect the PC directly to the router, use a straight-through Ethernet cable
to connect an Ethernet card on the PC to any one of the router’s switch ports.
See the following figure.
To connect via a LAN, use an Ethernet cable to connect the router’s switch
port(s) to the device(s) on the LAN. Select the LAN PC from which you wish to
configure the router. The PC should be in the same subnet as the part of the
LAN that contains the router. For example, the PC could be connected to a hub
or Layer 2 switch that is directly connected to one of the router’s switch ports.
See the following figure.
Router
Switch Ports
PC
ON
OFF
POWER
ASYN0 ADSL
PIC BAY
5 3 1
4 2
100-240 VAC 50/60 Hz 2.1 A
3 4 2 1
10BASE-T/100BASE-TX SWITCH PORTS
POWER
ON
OFF
ON
OFF
POWER
ASYN0 ADSL
PIC BAY
5 3 1
4 2
100-240 VAC 50/60 Hz 2.1 A
Router
PC Hub or Layer 2 Switch
Switch Ports