Installing a power supply unit or fan – Allied Telesis Removable Power Supply and Fan User Manual
Page 7
Removable Power Supply and Fan
6
Installing a Power Supply Unit or Fan
Use these instructions to install PSUs, chassis fans and FOMs.
■
Do not combine PWR01 and PWR02 PSUs in the same switch.
■
Do not combine AC and DC PSUs in the same switch.
Before you begin
■
Read the safety information for the switch.
Safety information is in the x900 Series Switch and SwitchBlade
®
x908
Installation and Safety Guide or the AT-10408XP Installation Guide. You can
download these documents from
■
Gather necessary tools and equipment.
No special tools are required to install PSUs or fans since they have captive
thumbscrews. However, you may need an appropriate screwdriver to tighten
or loosen them.
■
Verify the package contents if you have not already done so.
. Contact your authorised Allied Telesis
distributor or reseller if items are damaged or missing.
■
Remove the unit from its packing material in an anti-static environment.
Caution Follow correct anti-static procedures. Failure to do so could
damage the PSU, fan, or switch. If you are unsure about correct procedures,
contact your authorised Allied Telesis distributor or reseller.
Caution When adding or replacing power supplies, keep your hands and
fingers out the power supply bays. After installing a PWR05 power supply,
use a screwdriver to tighten the captive screw such that a screwdriver will
be required to remove the PSU at a later date.