Allied Telesis AlliedView-EMS 3.11 AMIGO - Manual (Page 24)

AlliedView™-EMS 3.11 AMIGO USERS GUIDE Page 24 of 43
4.1.6.1 Setting MIB-Files Tab
In the Setting MIB-Files tab, you can specify which MIB files AMIGO uses to draw the MIB
tree. To add a MIB file, enter a file name in the MIB-File name textbox then click Add or
select a MIB file using the Browse button. To remove a MIB file, select a file from the list
then click Delete.
Auto Add
Using the "Auto Add" button, you can automatically add the MIB files which are
required to manage the target device. When you click "Auto Add", MIB files which
are needed by the target hosts specified in the "Setting target devices" tab are added
to the MIB files list.
You can automatically add MIB files only if the target device is supported by
AlliedView-EMS.
Select MIB-Files tab
4.1.6.2 Setting Target Devices Tab
In the "Setting target devices" tab, you can add or remove a target device to/from which
MIB values are set or retrieved. You can also configure the SNMP connection properties of
a target device.