Allied Telesis AT-FS708POE - Manual (Page 38)

Chapter 2: Installation
38
Installing the Switch in a Rack
To install the switch in a rack, perform the following procedure:
1. If attached, remove the rubber feet using a flat-head screwdriver.
2. Attach a mounting bracket (provided) to each side of the switch using
the bracket mounting screws (provided), as shown Figure 8.
Figure 8. Attaching the Mounting Brackets
3. Mount the switch on a 19-inch rack using the screws (not provided), as
shown in Figure 9.
775
AT-FS
708/P
OE 8 po rt 10/1 00TX Unm anage d POE Switch w/1 SFP port POWER
1
2
3
4
5
6
7
8
PoE
SFP
UPLIN K PO RT
PD ON
PD ER R
LINK
ACT
CLAS S 1 LASER PRODUCT
1000Ba se-X
776
AT-FS
708/P
OE 8 po rt 10/100 TX Unm anage d POE Switc h w /1 SFP port POWER
1
2
3
4
5
6
7
8
PoE
SFP
UPLIN K POR T
PD ON
PD ER R
LINK
ACT
CLAS S 1 LASER PRO DUCT
1000Ba se-X