Allied Telesis AT-FS708POE - Manual (Page 19)

AT-FS708/POE Fast Ethernet Switch Installation Guide
19
LEDs
The system and port LEDs on the front panel of the AT-FS708/POE Fast
Ethernet switch switch display the switch and its port status information.
Table 2 describes the system LED.
Each twisted pair port has two LEDs, as described in Table 3.
Table 4 describes the SFP port LED.
Table 2. System LED
LED State Description
PWR Green The switch is powered ON and operating
normally.
OFF The switch has no power.
Table 3. Twisted Pair Port LEDs
LED State Description
L/A Green A valid link is established on the port.
Blinking Green Frames are being transmitted/received on the
port at 10 or 100 Mbps.
Off No link is established on the port.
PoE Green A PoE powered device is connected and is
being powered by the port.
Blinking Green PoE is off because an error occurred on the
powered device connected to the port.
OFF The port is not connecting to a valid powered
device.
Table 4. SFP Port LED
LED State Description
L/A Green A valid link is established on the SFP module in
the SFP expansion slot.
Blinking
Green Frames are being transmitted/received on the
SFP module in the SFP expansion slot.
OFF No link is established on the SFP module in the
SFP expansion slot.