Allied Telesis x600-48Ts/XP User Manual
Page 46
Chapter 3: Cabling the Network Ports
46
Installing Optional Transceivers
Review the following guidelines before installing an optional SFP or XFP
transceiver in a switch:
A transceiver can be hot-swapped; the switch can be powered on
when you install it. However, you should always disconnect the cables
first before removing a transceiver.
You must install the transceiver before you connect the cables to it.
Fiber optic transceivers are dust sensitive. When a fiber optic cable is
not installed, or when you store the transceiver, always keep the plug
in the optical bores. When you do remove the plug, keep it for future
use.
Unnecessary removal and insertion of a transceiver can lead to
premature failure.
Warning
A transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
device.
Installing an SFP
Transceiver
To install an SFP transceiver in an x600 switch, perform the following
procedure:
1. Remove the dust plug from a transceiver slot on the switch, as shown
Figure 22. Removing a Dust Plug from an SFP Slot
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
1322
23R
24R
CLASS
1
LASER PRO
DUCT
D/C
L/A
1000
LINK /
ACT
FDX
POR
T AC
25
L/A
XFP
SFP
21
22
23
24