Allied Telesis AT-GS900/8PS - Manual (Page 37)

AT-GS900/8PS Switch Installation Guide
37
Installing the Switch on a Desktop
You may install the AT-GS900/8PS Switch on a desktop or in a standard
19-inch equipment rack. To install the switch in a rack, refer to “Installing
the Switch in an Equipment Rack” on page 38.
To place the switch on a desktop, perform the following procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Turn the switch over and place it on a table.
3. Attach the four rubber feet to the bottom of the switch as shown in
Figure 5.
Figure 5. Attaching the Rubber Feet
4. Turn the switch over again and place it on a flat, secure surface (such
as a desk or table) leaving ample space around the unit for ventilation.
5. Go to “Installing Optional SFP Transceiver” on page 43 or “Cabling the
Switch” on page 45.