Allied Telesis AT-UWC Wireless LAN Controller - Manual (Page 7)

Installation Guide
7
Installing the AT-UWC WLAN Controller
To install AT-UWC WLAN Controller onto a server, you must boot the
server from the DVD or CD that the AT-UWC-Install ISO image is written
to.
You can install the AT-UWC WLAN Controller onto a PC-based server or a
virtual machine.
Requirements for
a PC-based
Server
To install the AT-UWC WLAN Controller onto a PC-based server, the PC
must meet the following requirements:

3.10 GHz or faster x86 processor

1 Gigabyte or larger RAM (4 Gigabyte is recommended)

80 Gigabyte or larger Hard Disk

DVD ROM

Gigabit Ethernet Network Interface Card compatible with the
IEEE 802.1q standard

Monitor

Keyboard
Supported
Virtual Machine
Platforms
The following list shows the supported virtual machine platforms:

VMware vSphere (v5.1)

Microsoft Windows Server 2008 R2 (Hyper-V 2.0)

Microsoft Windows 8 (Hyper-V 2.0)
Note
The procedures for installing the AT-UWC WLAN Controller onto a
virtual machine vary depending upon your virtual machine settings.
Refer to “Installing the AT-UWC WLAN Controller onto a PC,” next.
Installing the
AT-UWC WLAN
Controller onto a
PC
To install the AT-UWC WLAN Controller onto a PC, do the following:
1. Connect a monitor and keyboard to a PC.
2. Power on the PC and monitor.
Caution
When you boot a PC-based server with the DVD or CD, the
installation program deletes all the data in the HDD.