AFX HZP620SNSCTD - Manual

HZP Series
Fluorescent Pendant
Models 413/613
Page 1 of 2 8060464 Rev. 8
*MV model shown with 4-pin CFL’s
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
Make sure that the power source conforms to the requirements of the
fixture. (See labels on fixture housing).
Models ending in MV power source 120-277V Non-dimmable
Models ending in SCTD power source 120V (Self Ballasted
dimmable CFL) Usable on a dimming circuit with dimmable lamps
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel.
This fixture is intended for use as general lighting in dry or damp
locations.
Assembly Instructions
1. Preparing for installation.
A. Disconnect electrical power before installing or servicing any part of this fixture.
B. Unpack and lay out all fixture components to verify everything is included to fully assemble the fixture.
C. Please affix all stems with supplied thread locker to prevent stems from coming undone when assembled.
2. Fixture assembly - Lighting fixture is partially assembled
A. Take the fixture power wires (black and white) and feed them
through the 1-½” stem assembly (10). Thread the stem assembly
into the fitting on top of the ballast/lamp tray until secure.
B. Slide diffuser support (11-only found on 6-lamp unit) over 1
½” stem assembly and allow it to rest on top of the ballast/lamp
mounting tray. NOTE: Verify Step 2C is completed prior to
moving on for the 6-lamp unit only.
C. Feed wires through the ½” nipple (8B) and stem (9) and screw
the stem into nipple on top of the 1-½” stem (10).
NOTE: Two 6” and two 12” stems included for
desired height between 1-½” stem and canopy.
D. Slide wires through ½” threaded nipple (8A) and screw nipple
¼” into stem (9) and swivel assembly (6). Slide wires through
swivel (6) and canopy (5) assembly and tighten.
3. Fixture mounting.
A. Install short screws (2) provided into threaded holes near ends
of gem bar (3). Be sure these screws line up with holes in
canopy.
B. Insert 1 ½” (4) screws through slots in gem bar (3) and
secure to junction box in ceiling (not provided). Be sure short
screws (2) in gem bar (3) pointing down. Slide supply wires
through center hole of mounting bracket.
4. Wiring.
Caution: Make sure power is off at fuse or circuit breaker box. Check
power wires for damage or scrapes. If power supply wires are within
three inches of ballast use wire suitable for at least 90C (194F). Note:
Most dwellings built before 1985 have supply wire rated to 60C.
Consult a qualified electrician before installing.