AFX AEL232RBMV-CK - Manual (Page 2)

AEL-CK SERIES
Aeon
Models 232-CK/432-CK
Ceiling Mounted Fixture
•
Third, install the four cable wire sub-assemblies, to install you must place the four cable bottom holders (15) at the ¼ diameter holes as shown in Fig 2.
Note: Make sure the cable wires are all same length, (to adjust cable length, loosen-up the top portion of the cable bottom holder (15) then adjust to
proper length and tighten to secure the desired length.
•
Fourth, install the power cord bottom strain relief (12) at the 13/32 diameter hole near the ballast side as it is shown in Fig 2 and make sure to
mechanically secure it with the bottom 1/8IPS hex nut (14).
Note: Make sure the power cord length is longer (1/2 inch) than the cable wire length. (to adjust cord length, loosen-up the outside portion of the
strain relief (12) then adjust to proper length and tighten to secure the desired length.
6. Wiring the Fixture
A.
First, connect the ballast black wire with the wire nut provided to the black wire of the power cord (17), now, connect the ballast white wire with the wire nut
provided to the white wire of the power cord and with the wire nut provided connect the power cord green wire to the ground wire of the fixture (Fig 1).
B. Now, re-install the channel cover (2) to the channel (1) as per the instruction in Fig 3.
7. Installing the 4FT Metal Frame with the Two ¼-20 screws (Use Fig 5).
A.
Tip the 4ft metal frame as it shown in Fig 5 and make sure the frame bracket bent tab is on the hole of the socket bracket (19), then swing the other end of
the frame Up and against the socket bracket (18), now align the holes of the frame bracket (21) to the socket bracket (18) two holes. Now, you can install and
tighten the two ¼-20 x 5/8 screws. To install the screws, you have to start from the top of the socket bracket (18) and screwed on to the two threaded holes of
the frame bracket (21). Note hold on one hand and use the other hand to fasten the two screws.
Limited Factory Warranty
American Fluorescent Corporation hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under
normal operating conditions
for a period of 2 years from date of purchase from factory. This warranty covers all component parts and extends only to
replacement of defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
2 of 2
8060251 R1