Samsung LE40B650T2W - Manual (Page 50)

English - 48
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work. Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
Connect only one receiver (home theatre).
Check if the Anynet+ device power cord is properly connected.
Check the Anynet+ device’s Video/Audio/HDMI 1.3 cable connections.
Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
Check whether the TV remote control is in TV mode.
Check whether it is Anynet+ exclusive remote control.
Anynet+ doesn’t work in certain situations. (Searching channels, Operating
Media Play,
Plug & Play, etc.)
When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or
turn your TV off and on again.
Check if the Anynet+ Function of Anynet+ device is set on.
●
●
●
●
●
●
●
●
●
●
I want to start Anynet+. Check if the Anynet+ device is properly connected to the TV and check if the Anynet+ (HDMI-CEC)
is set to on in the Anynet+ Setup menu.
Press the TV button on the TV remote control to switch to TV. Then press the TooLS button to
show the Anynet+ menu and select a menu you want.
●
●
I want to exit Anynet+. Select View TV in the Anynet+ menu.
Press the SourCE button on the TV remote control and select a device other than Anynet+
devices.
Press
P >/<, PrE-CH, and FAV.CH to change the TV mode. (Note that the channel button
operates only when a tuner-embedded Anynet+ device is not connected.)
●
●
●
The message
‘Connecting to Anynet+
device...’ appears on the
screen.
You cannot use the remote control when you are configuring Anynet+ or switching to a view
mode.
Use the remote control when the Anynet+ setting or switching to view mode is complete.
●
●
The Anynet+ device does
not play.
You cannot use the play function when Plug & Play is in progress. ●
The connected device is
not displayed.
Check whether or not the device supports Anynet+ functions.
Check whether or not the HDMI 1.3 cable is properly connected.
Check whether
Anynet+ (HDMI-CEC) is set to on in the Anynet+ setup menu.
Search Anynet+ devices again.
You can connect an Anynet+ device using the HDMI 1.3 cable only. Some HDMI cables may not
support Anynet+ functions.
If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord
or a power failure, please repeat the device scan.
●
●
●
●
●
●
The TV program cannot
be recorded.
Check whether the antenna jack on the recording device is properly connected. ●
The TV sound is not
output through the
receiver.
Connect the optical cable between TV and the receiver. ●
¦
BN68-02325A-04Eng.indb 48 2009-10-08 �� 9:54:04