American Dryer Corp. SL20 - Manual (Page 13)

113191-2 11
The dryer will continue through the drying and cooling cycles,
until the vended time has expired.
Note
To stop dryer, open main door or pressing the pause
key. Continuation of the cycle will resume only after
the door has been closed and any of the three (3)
temperature selection is pressed.
Upon completion of the drying and cooling cycles, the tone
(buzzer) will sound and the dryer will go into the Anti-Wrinkle
Mode for 99 minutes, or until the main door has been opened.
Important
For more detailed information regarding the
microprocessor controller (computer) on your dryer,
refer to the microprocessor user’s manual included
with the dryer.
Non-Coin Models
The light emitting diode (L.E.D.) display reads “READY” (no
cycle in progress).
Press the letter on the keyboard (touch pad) corresponding
to the cycle desired (i.e., key “D”).
Note
“0-40” will require the “START/ENTER”
l
key to be
pressed after the number is selected in order to
accept the selection and start drying.
The dryer will then start. (i.e., blower, basket [tumbler], and
heat).
The L.E.D. display will read MANUAL DRYING CYCLE D, 00:00
MIN REMAIN.
Note
Press and hold the “UP ARROW” to view the basket
(tumbler) temperature at any time.
The dryer can be stopped at any time by pressing
the “STOP/CLEAR” O key, at this time the dryer will go into a
cycle pause. If the “STOP/CLEAR” O key is pressed again
at this point, the cycle that was in progress will be cancelled
and returned to the “READY” state.
Press and hold the “DOWN ARROW” to view the basket
(tumbler) RPM.
When the programmed drying time has expired, the Phase 7
non-coin microprocessor controller (computer) will proceed
into the Cool Down Cycle.
Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read COOL DOWN TEMP
___/___ MINUTES remaining. At the end of the heat cycle,
the dryer will shut off the heat and continue the fan and basket
(tumbler) until the Cool Down Time or temperature is reached.
Important
For more detailed information regarding the
microprocessor controller (computer) on your dryer,
refer to the microprocessor user’s manual included
with the dryer.
!
!
!
!
!
Shutdown Instructions _________________
If the dryer is to be shutdown (taken out of service) for a
period of time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the heat supply:
Gas Models - discontinue the gas supply.
Shut off external gas supply shutoff valve.