Using an external flash unit (purchased separately), P. 58), Hot-shoe (p. 58) – Samsung ES-NX10ZZSEB User Manual
Page 58
58
Using an external flash unit
(purchased separately)
You can use the A-TTL auto flash mode when you
attach an external flash unit (SEF20A or SEF42A) to the
camera.
This section of the user manual was prepared based on
the model SEF20A flash.
For more details about the external flash units, see the
flash units user’s manual.
Installing the flash
1
Install the external flash after removing the
hot shoe cover.
2
Turn on the external flash.
• The burst mode of external flash is set to
the TTL auto mode.
3
Make sure the external flash is fully
charged, and then start shooting.
The available flash modes
The flash modes available are determined by the
camera lens or camera exposure mode you are using.
1
Smart Flash Mode
• The camera automatically adjusts the brightness
of the flash according to amount of light in the
surrounding environment.
2
Auto
• The flash operates automatically in dim or dark
light.
3
Auto + Red
• The flash operates automatically in dim or dark
light and prevents the red-eye effect.
4
Fill in
• The flash operates whenever you take a picture
and its brightness is controlled automatically.
5
Fill-in Red
• Always operates the flash light, and prevents the
red-eye effect.
6
1st Curtain
• The flash operates immediately after the shutter
opens.
7
2nd Curtain
• The flash operates just before the shutter closes.
Taking a picture in a dark place
• Only a flash device manufactured for the NX series
automatically adjusts the brightness of the flash.
To enjoy the auto mode functions, please use the
flash manufactured for NX models. Although the
flash fires without the battery being fully charged, we
recommend using the flash only after you charge the
battery fully.
• If an external flash unit has a flash control function,
the light control value of the external flash is applied
when you connect it to the camera.