Samsung ES-NX10ZZSEB - Manual (Page 36)

36
Using the OIS in the menu option
After setting the OIS switch, select the OIS function in
the menu option
1
In Shooting mode, press [MENU].
2
Select Shooting3 ( 3 / 3 ) → OIS →
an option.
OIS
Mode 1
The OIS function is applied only when
pressing the shutter in full or half.
OIS
Mode 2 The OIS function is always applied.
The OIS function may not work well in the following
situations:
When you take a picture while tracing a moving
object
When a big vibration occurs beyond the range of
stabilization
When the shutter speed is too slow due to a
circumstance like night shooting
When the battery capacity is not sufficient
When you are shooting a close-up shot
When you use a tripod, please disable the OIS
function since the image can be shaken due to the
vibration of OIS function.
If the camera is struck or dropped while you are
taking a picture, the display can be impaired. If this
occurs, turn the camera off and then on, and the
camera should operate normally again.
Since the battery consumption can increase along
with the use of OIS function, it is recommended to
use the function only if needed.
To set the OIS function by using the menu, set
[OIS] of lens to ON. This function may not operate
depending on the lens model.
The function can be set directly by pressing [Fn] in
the shooting mode.
•
-
-
-
-
-
•
•
•
•
•