Samsung DVD-VR325-XAA - Manual (Page 15)

C
onnections
English - 15
Step 1: Unpacking
❚
Accessories
Check for the supplied accessories below.
• Video/Audio Cable (AC39-00073A)
• RF Cable for TV (AC39-42001J)
• HDMI-HDMI Cable (MF39-00299A)
• Remote Control (AK59-00034S)
• Batteries for Remote Control (AAA Size)
(AC43-12002H)
• User's Manual (AK68-00588E)
• Quick Guide (AK68-00589D)
• HDMI Setup Guide (AK68-00589E)
Step 2: Connecting the
Antenna Cable
There are several ways to connect your DVD Recorder &
VCR. Select one of the following antenna connections
that best suits you below.
• Method 1 : Antenna + DVD Recorder & VCR + TV : No
Cable box
• Method 2 : Antenna + Cable box + DVD Recorder &
VCR + TV : Cable box with many scrambled
channels
• Method 3 : Antenna + DVD Recorder & VCR + Cable
box + TV : Cable box with a few scrambled
channels
❚
Method1 : Antenna + DVD Recorder &
VCR + TV : No Cable box
You can record non-scrambled channels by selecting the
channel on the DVD Recorder & VCR. Also use this
method if you watch channels without a cable box.
RF Cable
❚
Method 2 : Antenna + Cable box +
DVD Recorder & VCR + TV :
Cable box with many
scrambled channels
You can record channels by selecting the channel on the
cable box. You cannot record one channel while watching
another channel. Be sure that the cable box is turned on.
Wall
Cable box
To RF IN
To RF OUT
RF Cable
To ANT INPUT
■
If you are using an off-air antenna that has 300-
ohm twin flat leads, use an external antenna
connector (300-75 ohm adaptor : not supplied)
to connect the antenna to the DVD Recorder &
VCR.
■
If you have two separate antennas (one VHF
and the other UHF), use a UHF/VHF combiner-
adaptor (available at most electronics shops) to
connect the antenna to the DVD Recorder &
VCR.
Note