Samsung RH269LBSH-XAA - Manual (Page 54)

54
USER INTERFACE
How to connect the AM Antenna.
The AM antenna can be :
- Placed on a stable surface.
- Fixed to the wall/base/floor, etc. (you must first remove/clean the base)
To assemble the AM loop antenna.
To connect the AM loop antenna cords.
- Connect black cord to the black terminal, and the white cord to the white terminal.
To avoid noise interference.
- Check that electronic equipment and DC adapter do not run close to the antenna wires. Always keep
them at least 20 inches (50cm) away.
How to connect the FM Antenna.
- Connect a 75( Ω) antenna to the FM antenna terminal.
- Plug the connector on the FM antenna supplied into the
coaxial socket (75 Ω)) marked FM on the rear of the system.
- Follow the instructions to tune into a radio station, and deter-
mine the best position for the antenna.
How to improve the Radio reception.
You can improve the quality of radio reception by :
- Spread the AM/FM antenna out and attach the ends to a wall, in the position providing the best reception.
- If reception is poor (e.g. distance from transmitter too close, walls blocking the radio waves, etc.), install an outdoor antenna.
- AM/FM Radio reception quality will depend on your location and the broadcast conditions.
NOTE
1. Extend the FM antenna.
2. Fasten it up in the position which gives you the best reception,
then fix it on the wall, etc.
- If reception is poor, you may need to install an outdoor antenna.
To do so, connect an outdoor FM antenna to the FM socket on
the rear of the system using a 75
Ω coaxial cable(not supplied).
DA99-01278D REV(0.0) 2006.10.17 10:9 PM 페이지54