Samsung DVD-HR720-XAA - Manual (Page 28)

28 - English
C
onnecting & Setting up
■ You must select a cable box brand from
the list in Screen 8 on page 159. If you do not
know the brand name, please contact your cable
provider. For more information, please refer to
pages 158~160.
■ After connecting cable box to the HDD & DVD
RECORDER through the IR Blaster cable, you must
follow the instructions in screen 4 on page 158.
NOTE
IR Blaster cable
G-Link wand
Front Panel of CABLE BOX
Connecting a Cable box to the G-Link jack
Your cable box (not supplied) receives Guide show listings from TV Guide On Screen System on the HDD &
DVD RECORDER through the IR Blaster cable. Connect your cable box to the G-Link jack on the rear panel
of the HDD & DVD RECORDER using the IR Blaster cable as shown. This connection enables you to control
the cable box's power and channels.
Getting Connected
1. Find and Connect the included G-Link cable into
the G-LINK jack of the HDD & DVD Recorder.
2. Find the Cable Box IR Sensor
To control cable box recording, find the IR sensor.
A. Turn the cable box Off.
B. Hold the cable box’s remote so that it touches
the front of the device (see Figure 1).
C. Move the remote across the front while pressing the
power button On and Off (Figure 2). (Press and
release the power button each time you move the
remote; holding down the button will not work.)
D. When the cable box powers On, you have
found the sensor.
E. Remember the location of the sensor.
3. Place the G-Link Wand
Place the G-LINK wand underneath the cable box
approximately 1 inch in front of the sensor you found in 2 .
Use the double-sided tape to secure the G-LINK wand.
Correct
Figure 1
Figure 2
Incorrect
1 inch
w
w
02-DVD-HR720_XAA_17-29_CONNECT 2005.9.9 3:34 PM Page 28