Troubleshooting for anynet – Samsung LN37A450C1XZP User Manual
Page 56
English - 54
troubleshooting for Anynet
+
Symptom
Solution
Anynet+ does not work.
■ Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
■ Connect only one receiver (home theater).
■ Check if the Anynet+ device power cord is properly connected.
■ Check the Anynet+ device’s Video/Audio/HDMI cable connections.
■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ Check whether the TV remote control is in TV mode.
■ Check whether it is Anynet+ exclusive remote control.
■ Anynet+ doesn’t work at a certain condition.
(Searching channels, Plug & Play, etc.)
■ When connecting or removing the HDMI cable, please make sure to search devices
again or restart your TV.
■ Check if the Anynet+ Function of Anynet+ device is set on.
I want to start Anynet+.
■ Check if the Anynet+ device is properly connected to the TV and check if the Anynet+
(HDMI-CEC) is set to On in the Anynet+ Setup menu.
■ Press the
tV button on the TV remote control to switch to TV. Then press the tOOLS
button to show the Anynet+ menu and select a menu you want.
I want to exit Anynet+.
■ Select
View tV in Anynet+ menu.
■ Press the
SOURCE button on the TV remote control and select a device other than
Anynet+ devices.
■ Press any of
Ch, Ch LISt, PRE-Ch to change the TV mode.
(Note that the channel button operates only when a tuner-embedded Anynet+ device
is not connected.)
the message “Connecting to
Anynet+ device...” appears on the
screen.
■ You cannot use the remote control when you are configuring Anynet+ or switching to a
view mode.
■ Use the remote control when the Anynet+ setting or switching to view mode is
complete.
the Anynet+ device does not play. You cannot use the play function when Plug & Play is in progress.
the connected device is not
displayed.
■ Check whether or not the device supports Anynet+ functions.
■ Check whether or not the HDMI cable is properly connected.
■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ Search Anynet+ devices again.
■ You can connect an Anynet+ device using the HDMI cable only. Some HDMI cables
may not support Anynet+ functions.
■ If it is terminated by an abnormal situation such as disconnecting the HDMI cable or
power cord or a power failure, please repeat the device scan.
the tV program cannot be
recorded.
Check whether the antenna jack on the recording device is properly connected.
BN68-01395E-Eng.indd 54
2008-03-24 ¿ААь 11:35:57