Samsung SGH-T929ZKDTMB - Manual (Page 101)

Applications 98
Voice Recognition
Nuance is an advanced speech recognition software used to activate a wide variety of functions on your phone.
Nuance software automatically voice activates (up to 2,000 contacts) for voice dialing and searching. No
pre-recording or training needed. Speak a contact name naturally to dial, and use your voice to look up contacts,
launch applications and navigate phone menus.
1. In Idle mode, touch Menu ➔ Applications ➔ Voice recognition.
2. At the voice prompt, say a command. The list of available commands is listed below.
Note: This list of voice commands is briefly displayed.
Say a Command Options
• Call : dials a name or number listed in your contact list. If multiple numbers exist (i.e. home, work,
or other) say the name and the number type (location).
• Send Text : displays the Create Text Message screen.
• Lookup : allows you use a voice command to locate and display contact information stored in the
Contacts list. For more information, refer to “Finding a Phonebook Entry” on page 51.
• Go to
Tasks, Phonebook, Voice mail, and Games and Apps.
• Check : lets you check your phone's status in the same report (Status, Messages, Missed Calls, Time,
Signal Strength, Network, Battery, My Phone Number, and Volume).
While the Say a command screen displays you have two options:
• Tutorial: provides examples of how to use the voice commands.
• Settings: lists the settings for voice command software such as: Confirmation, Adaptation, Modes, Speakerphone, and About.
If the phone does not recognize your command the Command not recognized screen displays with two options:
• Restart: touch and try the command options again.
Speak clearly when giving your command. There is no need for you to speak slowly or with added emphasis. The
voice recognition software has been optimized to understand your speech in its natural form. If it does not
recognize your command after a few seconds, a voice prompt asks you to repeat the command. If it does not
recognize your command again, the following message displays “Sorry, no match found,” and voice recognition
turns off.