Amana RS3100007 - Manual (Page 61)

RS3100007 Rev. 0 C–12
Care and Cleaning
Automatic Balance System
Your new washer will automatically adjust to
unbalanced loads without shutting down or interrupting
the cycle. The cycle will automatically complete at the
fastest spin speed possible.
In a severe out-of-balance condition, clothes may
contain excessive moisture. If this should happen,
simply redistribute the clothes, and reset the control to
the spin mark after the rinse setting in the regular
cycle.
Safety Spin
The washer will not spin when the lid is open for any
reason. This is for your personal safety. If the lid is
opened mid-cycle, operation will automatically start
when lid is closed.
General Washer Care
• Use only damp or sudsy cloth for cleaning control
panel. Some cleaning product sprays may harm
control panel finish or may damage interior of hood.
• Wipe washer cabinet as needed. If detergent,
bleach, or other washing products are spilled on
cabinet, wipe immediately. Some products will cause
permanent damage if spilled on cabinet.
• Top of washer should not be used for removing
garment stains. Some stain removers, such as rust
remover, may damage cabinet finish.
• Do not use scouring pads or abrasive cleansers.
• Do not lay sharp or rough objects on or against
washer. Finish could be damaged.
• Remove pins, buckles, or other sharp objects from
clothes to prevent scratching interior parts.
• Leave lid open after use to allow inside of washer to
dry, and to help prevent musty odors from
developing.
• Do not allow small children to play on or around
washer.
• Do not move washer without reinstalling
shipping brace (Part #38039) and shipping plug
(Part #38149). See instructions below for
reinstallation procedures.
Moving Washer to New Location
Replace shipping plug under motor. See illustration.
Refer to Installation Instructions for proper procedures
whenever washer is moved.
Shipping plug
Plug location
inside washer
cabinet