Amana RS3100007 - Manual (Page 33)

RS3100007 Rev. 0 A–4
POSITION AND LEVEL
WASHER
Position washer in final location on clean, dry, firm, and
level floor.
NOTE: To avoid damage to legs and base, do not slide
washer across floor if leveling legs have been
extended.
1. Loosen 7 /8" locknuts and extend front leveling legs.
Place rubber foot pads on all four leveling legs.
Adjust front 2 leveling legs until machine is level
side-to-side. Be sure machine does not rock. Tighten
locknuts up to washer base, or washer will move out
of position during operation.
2. Once front legs are adjusted, gently tilt washer
forward on front legs and lower into place to correctly
set rear self-leveling legs.
Check that washer is level front-to-back and side-to-side.
WASHER MUST NOT ROCK.
5
2. Level Rear Legs
Rubber
foot
pad
1. Level Front Legs
Lock
nut
Leveling
foot
CLEAN TUB AND
RUN THROUGH
ONE WASH
CYCLE WITHOUT
CLOTHES
CONNECT
POWER CORD
TO
ELECTRICITY
See Installation Requirements
section. Plug washer into
3-prong grounded outlet only.
6
7
Wipe tub with clean rag and soap
diluted in warm water to remove
any oil used in manufacturing. Use
household spray cleaner if
necessary.
Add water and detergent to
washtub, and run before first use.
Questions?
See Owner’s
Manual or call
Amana
Consumer
Affairs
Department
1-800-843-0304
Installation Instructions