Samsung RF31FMEDBSR-AA - Manual (Page 39)

operating _39
02 OPERA
TING
3. Foldable Shelf
To remove - After removing the Shelf Front, lift up
the Shelf and remove it.
To re-install - Hook the Shelf on the Angle Frame
and re-attach the Shelf Front to the Foldable Shelf.
After sliding the foldable shelf in and
folding it, the Shelf Front can be removed
for your convenience. If you use the self
without removing, be careful of its possible
separation.
4. Vegetable & Fruit Drawers
• Door Bins
Before removing the drawer, please remove
door bins fi rst as below.
To remove - Simply lift the bin up and pull
straight out.
CAUTION
• Sparkling Water Model Door Bins
To remove - Take the right side of the bin
out by lifting it at an angle along the guide,
and then take the left side out by pulling it
from the door.
- When removing and re-assembling the Bottom
Door Bin of the Sparkling Water model, open
the Cylinder Cover and tilt the Cylinder towards
the front first.
• Tilt up the front of the drawer and pull straight
out, and pull out the drawer after moving
slightly in the direction of the arrow.
To re-install
• Insert the drawer into the frame rails and push
back into place.
• Slide bin in above the desired location and
push down until it stops.
The drawers need to be removed before
the glass shelf above them can be lifted
out.
5. Flex Zone
To remove the Flex Zone – Pull the Flex door
out to full extension. Lift the Flex Zone up, pulling
it to your body with both hands.
To re-install the Flex Zone – Open the Flex door
to full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails, and
then lower the front until the whole Zone rests on
the rails.
CAUTION
DA68-02894A-11.indb 39 DA68-02894A-11.indb 39 2014. 6. 23. 1:38 2014. 6. 23. 1:38