Samsung RF31FMEDBSR-AA - Manual (Page 11)

setting up _11
01 SETTING
UP
With the door opened
1. Remove the 3 screws holding down the TOP
TABLE ( 1 ) and separate the connected wires.
2. Disconnect the two connectors ( 2 ) on the
left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, you must
remove it before removing the tube.
3. Pull and remove the hinge lever ( 5 ). Remove
the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
4. Open the door (more than 90°), lift from the
middle hinge and remove the door.
- Due to its design features, you can
disassemble and re-assemble the door when
the door is open. (The holes in the Door Shaft
and the Door Middle Hinge are deliberately
tilted at specific angles so that it is difficult to
disassemble and re-assemble with the door
closed.)
CAUTION
Place the door, inside facing up, on a non-
scratching surface.
Auto Closing Hinge Auto Closing Hinge
Check the direction Check the direction
Door Middle Hinge Door Middle Hinge
- If the Auto Closing Hinge is aligned to be
vertical as shown in the figure, align it to be
parallel by using the Door Middle Hinge. (Refer
to No.5 for the disassembly of the Door Middle
Hinge)
Do not use a flat head screwdriver to align
the Auto close Hinge. It may get damaged.
Use the Door middle Hinge instead.
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+). Remove the 2 hex head bolts
( 9 ) attached to the lower left and right door
hinges with an allen wrench (3/16”). Remove
the lower left and right door hinges ( 10 ).
CAUTION
CAUTION
2
3
4
Red Clip Red Clip
(1/4") (1/4")
5
6
7
Allen wrench Allen wrench
10
8
9
1
DA68-02894A-11.indb 11 DA68-02894A-11.indb 11 2014. 6. 23. 1:37 2014. 6. 23. 1:37