beautypg.com

Making minor adjustments to the doors, Installing the water dispenser line, How to adjust the level – Samsung RF31FMEDBSR-AA User Manual

Page 14

background image

14_

setting up

How to adjust the level

1. Open the freezer drawer and remove the lower

basket.

2. Insert a flat-blade screwdriver (-) into the notch

on the left control lever, and turn it counter-
clockwise to level the refrigerator. (You turn the
lever clockwise to lower the refrigerator and
counterclockwise to raise it.)

Both control levers must be touching the
floor to avoid possible personal injury or
property damage because of tipping.

If the right side is lower, perform the same
procedure, but with the right control lever.

It is difficult to remove the cover leg
front from the refrigerator, so we do not
recommend making small adjustments
with the control lever. Instead, refer to the
next page for the best way to make minor
adjustments to the doors.

CAUTION

MAKING MINOR
ADJUSTMENTS TO THE
DOORS

Remember, a leveled refrigerator is necessary
for getting the doors perfectly even. If you need
help, review the previous section on leveling the
refrigerator.

The left door is fixed. To make minor door
adjustments, adjust only the right door.

1. Pull out the flex door ( 1 ) to reveal the lower

hinge ( 2 ).

2. Insert the supplied allen wrench (5/32”) ( 3 )

into the shaft ( 4 ) of the lower hinge.

3. Adjust the height by turning the hex wrench

( 3 ) clockwise (

DOWN

DOWN

) or counter clockwise ( 

UP

UP

 ).

When you turn the hex wrench counter-
clockwise (

), the door will move up.

INSTALLING THE WATER
DISPENSER LINE

A water dispenser with a fi lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water fi lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20-125 psi (138 ~ 862Kpa) is required.

flat-blade screwdriver (-)

flat-blade screwdriver (-) Control Lever

Control Lever

3

1

2

3

4

Adjustment

Adjustment
part

part

Fixed part

Fixed part

DA68-02894A-11.indb 14

DA68-02894A-11.indb 14

2014. 6. 23.

1:37

2014. 6. 23.

1:37

This manual is related to the following products: