Samsung ML-2540-XAA - Manual (Page 44)

Troubleshooting_ 44
8.
troubleshooting
This chapter gives helpful information for what to do if you encounter an error.
This chapter includes:
• Redistributing toner
• Tips for avoiding paper curls
• Tips for avoiding paper jams
• Clearing paper jams
• Solving other problems
Redistributing toner
When the toner cartridge is near the end of its life:
• White streaks or light printing occurs.
• The LED blinks orange.
If this happens, you can temporarily improve print quality by redistributing
the remaining toner in the cartridge. In some cases, white streaks or light
printing will still occur even after you have redistributed the toner.
1. Open the front cover.
2. Pull the toner cartridge out.
3. Thoroughly roll the cartridge five or six times to distribute the toner
evenly inside the cartridge.
If toner gets on your clothing, wipe it off with a dry cloth and wash
clothing in cold water. Hot water sets toner into fabric.
Do not touch the green underside of the toner cartridge. Use the
handle on the cartridge to avoid touching this area.
4. Hold the toner cartridge by the handle and slowly insert the cartridge into
the opening in the machine.
Tabs on the sides of the cartridge and corresponding grooves within the
machine will guide the cartridge into the correct position until it locks into
place completely.
5. Close the front cover. Ensure that the cover is securely closed.
If the output tray is closed, open the output tray.
Tips for avoiding paper curls
1. Open the rear cover.
2. Pull down the pressure lever on each side.
1 Pressure lever
Keep the rear cover opened during printing.
Only use when the printout has more than 20 mm curl.