Nilfisk-ALTO SMART Sweeper/Scrubber 692003 - Manual (Page 24)

1-24 AMERICAN-LINCOLN
SMART
FILTER SHAKER
DUST CONTROL ON DUST CONTROL OFF
CONTROLS
Figure 16
Figure 17
FILTER SHAKER SWITCH (Only models with dust control)
The filter shaker switch is located on the instrument panel as shown in figure 16. By pressing and holding in
the upper half of the switch, it will activate the filter shaker motors for 20 to 30 seconds. Releasing the switch,
returns to the off position.
The dust control fan will stop when the filter shaker has been activated. The filter shaker will only operate with
the hopper in the “DOWN” position.
DUST CONTROL SWITCH
The dust control switch is located on the instrument panel as shown in figure 17. To turn on the dust control
system for normal sweeping, press the lower half of the switch.
WARNING
Turn the dust control switch to the center “OFF” position while wet sweeping. Water will damage the
filter and cause premature filter failure.