Nilfisk-ALTO SMART Sweeper/Scrubber 692003 - Manual (Page 18)

1-18 AMERICAN-LINCOLN
SMART
MACHINE PREPARATION
UNPACKING BATTERY
The battery is shipped separately on a pallet wrapped in plastic as shown in figure 3. Remove the plastic and
use a 2000 LB. (907KG) capacity lifting device to lower the battery into the battery compartment as shown in
figure 4.
USE A 2000 LB.
(907 KG) LIFTING
DEVICE TO
INSTALL BATTERY
Fig 3 Fig 4
3) Push machine down the ramp onto a flat surface.
4) Install battery.
-Turn the key to the “O” position
-Lift the hood up and pull the battery lever up to the right.
-Use a battery lifting device with a 2000 LB. (907KG) capacity to place the battery into the battery tray.
-Push battery lever down to the left to lock the battery into place.
-Plug the battery power connector into the machine power connector.
-Lower the hood into place.
5) Charge battery as shown in the manual. Read battery manufacturer literature for battery care and
maintenance.
WARNING
Do not charge batteries on a concrete grounded surface. Hydrogen gas is formed during the charging
operation and is explosive. Only charge batteries in a well ventilated area with the lid open. Avoid
any smoking, open flame, or electrical sparks.