Campbell Scientific NL100 Network Link Interface User Manual
Revision: 12/10, Nl100
Table of contents
Document Outline
- Revision and Copyright Information
- Warranty and Assistance
- Table of Contents
- NL100/105 Network Link Interface
- 1. Introduction
- 2. Preparing to Set Up the NL100/105
- 2.1 Computer to NL100/105 Physical Connection
- 2.2 Communication with the NL100/105
- 2.3 Port Configuration
- 2.4 NL100/105 Menu Options
- 2.4.1 Ver
- 2.4.2 Show
- 2.4.3 Edit
- 2.4.3.1 TLink Config
- 2.4.3.2 RS485 Config
- 2.4.3.3 CS I/O Config
- 2.4.3.4 RS-232 Config
- 2.4.3.5 Ethernet 10 Base-T
- 2.4.3.6 PakBus Address of the NL100/105
- 2.4.3.7 PakBus/Tcp Server Config
- 2.4.3.8 PakBus/Tcp Client Config
- 2.4.3.9 MODBUS/TCP Gateway Config
- 2.4.3.10 Telnet IP Port Number
- 2.4.3.11 DevConfig Security Code
- 2.4.4 Defaults
- 2.4.5 Reset
- 2.4.6 Help
- 2.4.7 Bye
- 2.4.8 Other Commands
- 2.4.9 Serial Server Watchdog
- 3. Connecting the NL100/105 to a Network
- 3.1 Network to NL100 Connection
- 3.2 Typical Configurations
- 3.2.1 Direct Connect from the NL100/105 to a Datalogger
- 3.2.2 MD9 Connection from NL100/105 to Datalogger
- 3.2.3 MD485 Connection from NL100/105 to Datalogger
- 3.2.4 RF Connection from NL100/105 to Datalogger
- 3.2.5 Short Haul Modem Connection from NL100/105 to Datalogger
- 3.2.6 Phone Modem Connection from NL100/105 to Datalogger
- 3.3 NL100/105 to Datalogger Connections - CR9000/CR5000
- Appendix A. CS I/O Port
- Appendix B. Null-Modem Cable
- Appendix C. 10 Base-T Cabling
- Appendix D. RS-485 Connector, 3-Pin Terminal Block
- Glossary
- Campbell Scientific Contact Information