Campbell Scientific HS2 and HS2P (HydroSense II) - Manual (Page 40)

Appendix A. Configuration Menus
A.8 Time Synchronization
The HydroSense II uses its GPS to provide a very accurate clock. Whenever a
valid GPS signal is detected, the clock is adjusted using the received time (in
UTC) and the configured time zone. To use GPS synchronization, select ON
from the list, or OFF to ignore the GPS time. This menu item does not disable
GPS position. After highlighting a selection from the list, press
. To quit
the menu, press .
A.9 Display Settings
This submenu contains a list of settings related to the screen of the HydroSense
II. Using the buttons, highlight one of the options shown and press
. Alternatively, press to exit the menu.
A.10 Contrast
The contrast of the LCD can be affected by extremes of temperature or
lighting. This menu controls screen contrast. Press the button to lower the
contrast (make the image lighter) or the button to increase contrast (darker).
Please note that the highest and lowest contrast settings should only be required
in the most extreme conditions. Press
to save the new setting and to
exit.
A-4