Campbell Scientific CSIM11 pH and ORP Sensors - Manual (Page 12)

CSIM11 pH and ORP Probes
7. After selecting the sensors, click at the left of the screen on Wiring
Diagram to see how the sensor is to be wired to the datalogger. The
wiring diagram can be printed out now or after more sensors are added.
8. Select any other sensors you have, then finish the remaining Short Cut
steps to complete the program. The remaining steps are outlined in Short
Cut Help, which is accessed by clicking on Help | Contents |
Programming Steps.
9. If LoggerNet, PC400, or PC200W is running on your PC, and the PC to
datalogger connection is active, you can click Finish in Short Cut and you
will be prompted to send the program just created to the datalogger.
10. If the sensor is connected to the datalogger, as shown in the wiring
diagram in step 7, check the output of the sensor in the datalogger support
software data display to make sure it is making reasonable measurements.
4.2 CSIM11-ORP Tutorial
1. Install Short Cut by clicking on the install file icon. Get the install file
from either www.campbellsci.com , the ResourceDVD, or find it in
installations of LoggerNet, PC200W, PC400, or RTDAQ software.
4