Campbell Scientific CS110 Electric Field Meter - Manual (Page 53)

Appendix C. CS110 Connector Pin-outs
The following information describes the connectors that mate with the built-in
(bulkhead) connectors on the CS110. Connector pin numbering for the 6 and 9
pin connectors are shown below. The view is a view of the solder-cup side of
the cabled connector. The circular connectors are Mini-Con-X type from
Conxall. The CSI part numbers shown for the connectors include the
backshell. CSI fills the backshell with a relatively thick epoxy to seal and
provide strain relief.
1
3
2
6
4
5 1
4
2 9
5
7
3 8
6
POWER CONNECTOR
CS110CBL3-L CS110 Power Cable
Connector is female and is CSI PN 17654 (Conxall #6282-6SG-522 or
Switchcraft #EN3C6F). Pin 1 is indicated with a dot.
Pin Description Color
1 C1 Control Port 1 Blue
2 +12 V Power Red
3 Gnd Digital Ground Drain (clear)
4 P_Gnd Power Ground Black
5 C3 Control Port 3 Green
6 C2 Control Port 2 Yellow
WIND CONNECTOR
Connector is male and is CSI PN 9889 (Conxall #6282-6PG-522 or Switchcraft
#EN3C6M). Pin 1 is indicated with a dot.
Pin Description
1 2LO
Single-ended channel 4
1 1Mohm Pin 1 also connects to ground via a 1 Mohm 1% 50ppm resistor
2 Gnd Panel Ground
3 EX2 Excitation channel 2
4 P1 Pulse channel 1
5 Gnd Power ground
6 Gnd Ground
C-1