Campbell Scientific CM110, CM115, CM120 Tripod Installation - Manual (Page 16)

Tripod Installation Manual Models CM110, CM115, CM120
A
B
FIGURE 6-3. Mast attachment to tripod base
Secure the mast in the upright position by installing the locking bracket
(FIGURE 6-4A). Insert the top of the bracket into the notches in the tripod
base, and using both thumbs, press the bracket into the body of the base until
the lower tabs lock into position (FIGURE 6-4B). Install the pin as shown in
FIGURE 6-4C. To remove the bracket, remove the pin and squeeze the lower
part of the bracket to disengage the tabs, then rotate the bracket out and up.
Plumb the tripod by adjusting the northeast and south facing legs. With a level
on the east side of the mast, adjust the northeast leg for plumb. With the level
on the south side of the mast, adjust the south leg for plumb.
Wire
Retainer
Right-Angled Hole
Pin
8