Samlex America SA-1500 - Manual (Page 33)

31
Switch on the front plate of the inverter is done as follows:
This procedure acts as a toggle i.e. If the inverter was in
enabled state before the procedure, it will switch to disabled
state after the procedure.
Likewise, if it was in disabled state before the procedure, it will
switch to enabled state after the procedure.
Switch off all the loads, switch off the inverter, disconnect all
loads. Switch on the inverter. There will be 2 beeps and
green led will start flashing with a flashing sequence of flash-
flash-flash… (it will flash for approx. 3 seconds).
Immediately after it starts flashing, switch off the power on /
off switch and immediately switch on again. This will complete
the switching procedure. The inverter will continue its power
on sequence and switch over to the new state.
The power on / off switch should be switched off and on again
during the time the green led is flashing (the green led will
flash with a sequence of flash-flash-flash… For about 3
seconds after the inverter is powered on).