Samlex America SA-1500 - Manual (Page 28)

26
9. Appendix C
9-1. Remote Control Operations: ( Optional accessory )
System Configuration:
9-1-1. Plug the 9-pin D-SUB connector of the remote controller in the RS-232
port of the Inverter.
9-1-2. Check the setting of DIP-SW S5 & S6, The communication BAUD
RATE should be set to 4800bps (S5 & S6 OFF).
LED Indications:
9-1-3. Turn on the switch of the Inverter, There will be two short beep sounds
from the Inverter. All LEDS will be ON and, one second later, there
will be a short Beep sound. The amber, green and red LEDS of
remote controller will be on for 0.5 second then off sequentially. The
Inverter is then in the OFF mode.
The amber LED will be blinking every 2~3 seconds.
9-1-3-1. Remote Controller LEDS:
Color / Status Power Saving Power Output
Green ”ON” Enable ON
Green “Blinking” Enable OFF
Amber “ON” Enable ON
Amber “Blinking” Enable OFF
Green ：Power saving enable.1
Amber ：Power saving disable.
On ：Power On
Blinking ：Power Off